Brazed Heat Exchanger

Plate Arrangement
Standard plate arrangement forms two independent circuits running in alternate layers. The two fluids will flow in opposite directions (counter flow) to further enhance the exchange of heat. Specially-designed corrugated plates are used to increase the heat transfer coefficient and lower potential fouling.

Brazed Construction
The heat exchangers are brazed in a vacuum furnace and helium pressure tested to insure leak-free performance.

Two Compressor Technology
With the WCR 2C Series, Two compressor design has two independent refrigerant circuits, one on the left side and one on the right front side of the unit. The fluid side connections are on the reverse side, for easier access and chiller design.

The 2C series heat exchanger is based on the principal of having two refrigerants "interlaced" or alternating between the fluid circuits, thus allowing full 100% refrigerant contact with the fluid side. So, when only one compressor operates, 100% of the fluid is being chilled (evaporator mode) or heated (condenser mode).