Plate Arrangement
Standard plate arrangement forms two independent circuits running in
alternate layers. The two fluids will flow in opposite directions
(counter flow) to further enhance the exchange of heat. Special
designed corrugated plates are used to increase the heat transfer
coefficient and lower potential fouling.
Brazed
Construction
The heat exchangers are brazed in a vacuum furnace and helium
pressure tested to insure leak-free performance.
Two
Compressor Technology
With the WCR 2C Series, Two compressor design has two independent
refrigerant circuits, one on the left side and one on the right
front side of the unit. The fluid side connections are on the
reverse side, for easier access and chiller design. The 2C series
heat exchanger is based on the principal of having two refrigerants
"interlaced" or alternating between the fluid circuits, thus
allowing full 100% refrigerant contact with the fluid side. So, when
only one compressor operates, 100% of the fluid is being chilled
(evaporator mode) or heated (condenser mode)
 |
|
